Acin Settings - Xantrex Freedom SW 230V 815-3524-02 Owner's Manual

Sine wave inverter/chargers, xanbus enabled
Table of Contents

Advertisement

Configuring the Freedom SW using the SCP

ACIn Settings

The ACIn Settings menu configures the voltage and frequency
limits for AC Input quantification range. These are the limits at
which the Freedom SW 230V considers input voltage qualified—
that is, suitable for charging batteries or powering loads. If the input
voltage is not qualified according to these settings, the Freedom SW
230V transfers from using AC input to inverting.
FSW3524E 00: ACIn Settings
ACIn Breaker
[30A]
ACIn Lo Volt
[170V]
ACIn Hi Volt
[270V]
ACIn Lo Freq
[45Hz]
ACIn Hi Freq
[55Hz]
Figure 31 ACIn Settings Menu Screen
Table 14 Setting Defaults and Ranges
Model
Freedom SW 230V
Item
Default
Min
ACIn Breaker
30A
5A
ACIn Lo Volt
202V
170V
ACIn Hi Volt
260V
240V
56
Follow procedures on "To select and change a
configurable setting:" on page 38 to change the settings.
Max
30A
220V
270V
Table 14 Setting Defaults and Ranges
Model
Freedom SW 230V
Item
Default
Min
ACIn Lo Freq
45Hz
40Hz
ACIn Hi Freq
55Hz
52Hz
Table 15 ACIn Settings Menu Description
Item
Description
Sets the ACIn (Shore) breaker size, based on the size of the breaker
ACIn Breaker
installed on ACIn. The installed breaker size must not exceed the capacity
of the upstream distribution panel. The Freedom SW 230V limits the
maximum input current to this setting by derating its charging current to
an equivalent of 80% of the AC breaker size. If the connected loads
exceed the ACIn breaker setting, the AC breaker trips.
Minimum acceptable input voltage level from the utility mains.
ACIn Lo Volt
NOTE: It is recommended to leave this setting to its default value and not
to set it to the maximum allowed. Doing so might inadvertently derate
charging power in jurisdictions where the nominal AC mains voltage or
generator output is at 220 volts.
Maximum acceptable input voltage level from the utility mains.
ACIn Hi Volt
Minimum acceptable utility mains input frequency.
ACIn Lo Freq
Maximum acceptable utility mains input frequency.
ACIn Hi Freq
Max
48Hz
68Hz
Freedom SW 230V Owner's Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Freedom sw 230v 815-2524-02Freedom sw

Table of Contents