Table of Contents
Advertisement
Configuring the Freedom SW using the SCP
Setting the Device Number
Setting the device number gives a Xanbus-enabled device a unique
identity when several devices of the same type are installed in the
power system network. When each identical device has a unique
number, the Xanbus SCP can correctly identify and display status
information for each device. A device number consists of two digits
ranging from 00 (default) to 31.
If only one of each type of device is installed in the network, you do
not need to set the device number. However, setting the device
number to a value other than 00 is recommended in case you need to
use the Restore Defaults command (which resets the device
number to 00). After performing the command, checking that the
device number has returned to 00 indicates that the command was
successfully completed.
To set the Freedom SW 230V device number:
1. On the Freedom SW 230V Setup menu, select
Advanced Settings.
If Basic Settings appears instead of Advanced Settings
on the Setup menu, display Advanced Settings by pressing
Enter + Up arrow + Down arrow simultaneously.
On the Advanced Settings menu, select Stacking and press
Enter.
2. On the Stacking menu, select Dev Number.
Press Enter to highlight the instance number.
3.
60
4.
Use the up and down arrow buttons to adjust the two-digit
identifier number.
Press Enter.
5.
FSW3524E 00: Stacking
Dev Name
[ FSW3524E ]
Dev Number
[01]
Stack Mode
[Master]
3
FSW3524E 00: Stacking
Dev Name
[ FSW3524E ]
Dev Number
[01]
Stack Mode
[Master]
Figure 34 Setting a Device Number
FSW3524E 00: Stacking
Dev Name
[ FSW3524E ]
Dev Number
Stack Mode
[Master]
5
4
Steps 1 and 2 are not
shown.
Freedom SW 230V Owner's Guide
[*01]
Advertisement
Table of Contents
Troubleshooting
