Cisco TelePresence Server 7010 Product User Manual page 78

Field Field description
Cameras Select this check box for
are cross endpoint groups whose
connected outermost camera views cross.
This option is only available for
endpoint groups.
Field Field description
Address The IP address, host name, E.164
address, or URI of the endpoint.
Call Select either H.323 or SIP from the
protocol drop-down list.
Call Select this option to allow the
direct TelePresence Server to call this
endpoint directly, via its IP address,
instead of using the H.323 gatekeeper
or SIP registrar (or trunk).
Send Enter a string of DTMF characters if
DTMF required.
Cisco TelePresence Server Product User Guide
Usage tips
Call-out parameters
Usage tips
The TelePresence Server uses this information to
contact the endpoint when it invites the endpoint to join
a conference.
For H.323 calls, you can configure this endpoint or
endpoint group as needing to be reached via an H.323
gateway. To do this, set this field to be <gateway
address>!<E.164>.
Not applicable to Cisco CTS endpoints which always
use SIP.
If the box is unchecked, which is the default setting, the
TelePresence Server attempts to call the endpoint via a
gatekeeper, registrar or trunk (depending on the
server-wide system settings and the protocol the
endpoint uses).
This option does not apply to legacy Cisco
CTS endpoints, which must be called via a registrar or
trunk.
If the endpoint needs a sequence of tones after
connection, the TelePresence Server will send the
tones matching the string you enter. The TelePresence
Server supports the tones for the characters 0-9, A-D,
* and #.
The TelePresence Server ignores invalid characters
but continues sending tones for valid characters until it
reaches the end of the string.
Endpoints and endpoint groups
Page 78 of 151