Cisco TelePresence Server 7010 Product User Manual page 24

The IP address pattern and mask
n
Where matching packets will be routed, with the possibilities being:
n
Port A - meaning the default gateway configured for Port A
l
Port B - meaning the default gateway configured for Port B
l
<IP address> - a specific address has been chosen
l
Whether the route has been configured automatically as a consequence of other settings, or manually
n
added by you.
The default routes are configured automatically by your choice of Default gateway preferences for IPv4
and IPv6 (see Port preferences) and cannot be deleted. Any packets destined for addresses that are not
matched by your manually configured routes will be routed via the default gateway.
You can delete manually configured routes. Select the check boxes next to the routes then click Delete
selected.
Routes behavior with disabled ports
If the default gateway preference is set to Port B but that port is disabled, the default route will
automatically update to route unrecognised addresses via Port A.
If a manually configured route specifies Port B's default gateway but that port is disabled, packets
matching that route will be discarded. They will not be automatically routed via Port A. You must take
care to avoid this situation.
Current routes table
This table shows the IPv4 and IPv6 default gateways for each of the TelePresence Server's Ethernet
ports. If you want to change the default gateways for the Ethernet ports, go to
Network > Port B.
Cisco TelePresence Server Product User Guide
Network settings
Network > Port A or
Page 24 of 151