Reset Button; Console Port - Cisco Catalyst 6500 Series Installation Manual

Supervisor Engines
Supervisor Engines
Note
Table 1-2 Supervisor Engines
Product Number
1
Supervisor Engine 1
WS-X6K-SUP1-2GE
WS-X6K-SUP1A-2GE
WS-X6K-S1A-MSFC2
Catalyst 6500 Series Switch Module Installation Guide
1-8
This section describes the features found on Supervisor Engine 1, Supervisor
Engine 2, and Supervisor Engine 720. This section contains the following topics:
LEDs, page 1-12
•
• RESET Button, page 1-13
CONSOLE Port, page 1-13
•
CONSOLE PORT MODE Switch, page 1-14
•
Switch Load, page 1-15
•
PCMCIA Slot, page 1-15
•
• Uplink Ports, page 1-15
The Catalyst 6513 switch requires a Supervisor Engine 2 or Supervisor
Engine 720.
The supervisor engine configurations are listed in
Description
Supervisor Engine 1, dual 1000BASE-X GBIC uplinks
•
QoS port architecture (Rx/Tx) is 1q4t/2q2t
•
Supervisor Engine 1A, dual 1000BASE-X GBIC
•
uplinks
QoS port architecture (Rx/Tx) is 1p1q4t/1p2q2t
•
Supervisor Engine 1A, dual 1000BASE-X GBIC
•
uplinks, PFC and MSFC2 daughter cards
QoS port architecture (Rx/Tx) is 1p1q4t/1p2q2t
•
Chapter 1 Product Overview
Table 1-2.
78-15725-02