Reset Button; Back Panel - Cisco 550XG Series Quick Start Manual

10g stackable managed switches

Hide thumbs Also See for 550XG Series:

Table of Contents

XG—(Green) Located on the right of a 10G port. Lights steady when

another device is connected to the port, is powered on, and a 10 Gbps link

is established between the devices. When the LED is off, the connection

speed is under 10 Gbps or nothing is cabled to the port.

Gigabit—(Green) Located on the right of the OOB port. Lights steady when

another device is connected to the port, is powered on, and a

1000 Mbps link is established between the devices. When the LED is off,

the connection speed is under 1000 Mbps or nothing is cabled to the port.

SFP+ (if present)—(Green) Located on the right of a 10G port. Lights

steady when a connection is made through the shared port. Flashes when

the port is passing traffic.

Reset Button

The switch can be reset by inserting a pin or paper clip into the Reset

button opening on the front panel of the switch. See

Returning the Cisco

550XG Switches to the Factory Default Settings

for details.

The power port and console port are located on the back panel of the

switch.

Power—Connects the switch to AC power.

RPS2300—Connects the switch to the Cisco RPS2300 module. The Cisco

RPS2300 can provide backup power to the switch when the main power

supply has a failure.

Console—Connects a serial cable to a computer serial port so that it can

be configured by using a terminal emulation program.

Cisco 550XG Series 10G Stackable Switches Quick Start Guide

Table of Contents