Cisco Catalyst 6500 Series Installation Manual page 107

Chapter 1 Product Overview
Note
Figure 1-53 24-Port FXS Analog Interface Module (WS-X6624-FXS)
WS-X6624-FXS
24 PORT FXS ANALOG STATION
Table 1-22 24-Port FXS Analog Interface Module LEDs
LED Color/State
STATUS Green
Orange
Red
Off
78-15725-02
When installing the WS-X6624-FXS analog interface module in a chassis, you
must have a system ground cable attached to the chassis. Refer to the
Catalyst 6000 Series Switch Installation Guide or the Catalyst 6500 Series Switch
Installation Guide for the system grounding cable installation procedure.
When the 24-port FXS analog interface module is powered up, it initializes
various hardware components and communicates with the supervisor engine.
The front panel LEDs are described in
Description
The module is online and operational.
The module is booting or running diagnostics.
The supervisor engine has disabled the module.
The supervisor engine has sent an "SCP_SET_DIAG_FEATURES"
message indicating that the diagnostics have failed.
An overtemperature condition has occurred. (A minor temperature
threshold has been exceeded during environmental monitoring.)
The module processor powered up but is not running.
The module processor detected a fatal error during its diagnostics.
An overtemperature condition has occurred. (A major temperature
threshold has been exceeded during environmental monitoring.)
The module is not receiving power. The module was powered down
due to insufficient power. (The module is listed as power-deny in the
show module status field.)
Table 1-22.
Catalyst 6500 Series Switch Module Installation Guide
Voice-Related Modules
1-83