10/100 And 10/100/1000 Ethernet Switching Modules - Cisco Catalyst 6500 Series Installation Manual

10/100 and 10/100/1000 Ethernet Switching Modules

10/100 and 10/100/1000 Ethernet Switching Modules
Note
Note
Catalyst 6500 Series Switch Module Installation Guide
1-16
For detailed information on these ports, see the
Ports—Supervisor Engine Only" section on page
The Supervisor Engine 720 has two uplink ports. The port labeled PORT 1
requires that a Small Form-Factor Pluggable (SFP) module be installed into it.
The port operates at 1 Gbps. The port labeled PORT 2 has two connectors: either
an SFP 1-Gbps port connector or a 10/100/1000BASE-T RJ-45 connector.
In this chapter, the term Catalyst 6500 series modules refers to modules that can
be installed in either the Catalyst 6000 series switch chassis (Catalyst 6006 and
Catalyst 6009 switches) or the Catalyst 6500 series switch chassis (Catalyst 6503,
Catalyst 6506, Catalyst 6509, Catalyst 6509-NEB, and Catalyst 6513 switches)
unless specifically noted.
Specific combinations of supervisor engines and modules may not be supported
in your chassis. Refer to the release notes for the software version running on your
system for specific information on modules and supervisor engine combinations
that are not supported.
This section describes these Catalyst 6500 series 10/100 and 10/100/1000
Ethernet switching modules:
24-Port 10BASE-FL Ethernet Switching Module (WS-X6024-10FL-MT),
•
page 1-20
48-Port 10/100/1000BASE-T Ethernet Switching Module
•
(WS-X6148-GE-TX), page 1-21
48-Port 10/100/1000BASE-T Ethernet Switching Module
•
(WS-X6148V-GE-TX), page 1-21
48-Port 10/100BASE-T Ethernet Switching Module (WS-X6148-RJ21V),
•
page 1-22
48-Port 10/100BASE-T Ethernet Switching Module (WS-X6148-RJ45V),
•
page 1-23
Chapter 1 Product Overview
"Connecting to the Uplink
3-16.
78-15725-02