24-Port 100Base-Fx Fabric-Enabled Ethernet Switching Module (Ws-X6524-100Fx-Mm); 48-Port 10/100/1000Base-T Ethernet Switching Module (Ws-X6548-Ge-Tx) - Cisco Catalyst 6500 Series Installation Manual

Chapter 1 Product Overview
24-Port 100BASE-FX Fabric-Enabled Ethernet Switching Module
(WS-X6524-100FX-MM)
Note
Figure 1-18 24-Port 100BASE-FX Fabric-Enabled Ethernet Switching Module (WS-X6524-100FX-MM)
WS-X6524-100FX-MM
24 PORT 100FX-MMF
1 2 3 4 5
STATUS
48-Port 10/100/1000BASE-T Ethernet Switching Module
(WS-X6548-GE-TX)
78-15725-02
The 24-port 100BASE-FX switching module (WS-X6524-100FX-MM) provides
24 switched, 100-Mbps, full- or half-duplex ports. (See
MT-RJ connectors for MMF cable. The WS-X6524-100FX-MM module has
1-MB per-port packet buffers and a single fabric channel interface. The switching
module is upgradable to support distributed forwarding with an optional
Distributed Forwarding Card (WS-F6K-DFC).
This module is a Class 1 laser product. Refer to the Regulatory Compliance and
Safety Information for the Catalyst 6500 Series Switches for information on
working with lasers.
The QoS port architecture (Rx/Tx) for this module is 1p1q0t/1p3q1t.
6 7 8 9 10 11 12 13
The front panel LEDs are described in
The 48-port 10/100/1000BASE-T switching module (WS-X6548-GE-TX)
provides 48 switched, 10/100/1000-Mbps autosensing, full- or half-duplex ports.
(See Figure 1-19.) The module has 48 RJ-45 connectors for use with either
Category 3, Category 5, Category 5e, or Category 6 UTP cable. This module can
be upgraded with an inline-power daughter card to support IP phones.
10/100 and 10/100/1000 Ethernet Switching Modules
14 15 16 17 18 19 20 21
Table 1-6 on page
Catalyst 6500 Series Switch Module Installation Guide
Figure 1-18.) Ports have
22 23 24
1-47.
1-31