Factory Reset Button; Ports And Status Indicators; Package Contents - Cisco Meraki MS120 Series Installation Manual

Factory Reset Button

If the button is pressed and held for at least five seconds and then released, the switch will reboot and be restored to its original factory settings by deleting all
configuration information stored on the unit.

Ports and Status Indicators

The MS uses LEDs to inform the user of the device's status. When the device powers on, all the Internet LEDs flash twice. Additional functions are described
below, from left to right.
Function
Power Solid orange
Flashing white
Solid white
Off
Restore N/A
Switch Ports Off
Flashing orange (RJ45 ports only)
Solid green
Management Interface
Green
In addition, there is a RESTORE button available on the front panel.
Insert a paperclip if a restore is required.
•
A brief, momentary press: To delete a downloaded configuration and reboot.
•
Press and hold for more than 10 sec: To force the unit into a full factory restore.
Equipment is to be used only in a restricted access location and installed/operated only by trained service personnel.

Package contents

In addition to the MS switch, the following are provided:
LED Status Meaning
Switch is unable to connect to the Meraki cloud
Firmware upgrade in process
Switch is fully operational and connected to the Meraki cloud
Switch does not have power
Restore button to clear switch IP and local configuration settings
No link is detected on this port
Activity indicator
1 Gbps link detected
Connected, used for easy access to the local status page
3