Cisco Catalyst 6500 Series Installation Manual page 149

Chapter 3 Installing the Module
c.
d.
e.
f.
78-15725-02
Using the thumb and forefinger of each hand, grasp the two ejector levers and
exert a slight pressure to the left, deflecting it approximately 0.040 inches
(1 mm) creating a small gap between the module's EMI gasket and the
module adjacent to it. (See
Do not exert too much pressure on the ejector levers because they will
Note
bend and get damaged.
While pressing down on the ejector levers, simultaneously close the levers to
fully seat the supervisor engine or module in the backplane connector. The
ejector levers are fully closed when they are flush with the module faceplate.
(See Figure 3-6.)
Tighten the two captive installation screws on the module.
Make sure that the ejector levers are fully closed before tightening the
Note
captive installation screws.
Verify that the supervisor engine or module STATUS LED is lit. Periodically,
check the STATUS LED. If the STATUS LED changes from orange to green,
the supervisor engine or module has successfully completed the boot process
and is now online. If the STATUS LED remains orange or turns red, the
supervisor engine or module has not successfully completed the boot process
and may have encountered an error. For more information about the orange
or red STATUS LED states, see the LED table for your specific module in
Chapter 1.
Catalyst 6500 Series Switch Module Installation Guide
Installing a Supervisor Engine or a Switching Module
Figure 3-5.)
3-11