48-Port 10/100Base-T Ethernet Switching Module (Ws-X6248A-Tel); 24-Port 100Base-Fx Ethernet Switching Module (Ws-X6324-100Fx-Mm); (Ws-X6324-100Fx-Mm) - Cisco Catalyst 6500 Series Installation Manual

10/100 and 10/100/1000 Ethernet Switching Modules
48-Port 10/100BASE-T Ethernet Switching Module
(WS-X6248A-TEL)
Figure 1-12 48-Port 10/100BASE-T Ethernet Switching Module (WS-X6248A-TEL)
WS-X6248-RJ-TEL
24-Port 100BASE-FX Ethernet Switching Module

(WS-X6324-100FX-MM)

Note
Catalyst 6500 Series Switch Module Installation Guide
1-26
The 48-port 10/100BASE-T Ethernet switching module (WS-X6248A-TEL)
provides 48 switched 10/100-Mbps autosensing, full or half-duplex ports. (See
Figure 1-12.) The WS-X6248A-TEL Ethernet module has a larger buffer than the
WS-X6248-TEL Ethernet module. Four RJ-21 connectors (12 ports per
connector) use Category 3, Category 5, Category 5e, or Category 6 UTP or FTP
cable to connect to the network.
The QoS port architecture (Rx/Tx) for this module is 1q4t/2q2t.
48 PORT ETHERNET SWITCHING
10/100 BASE-T MODULE
The front panel LEDs are described in
The 24-port 100BASE-FX switching module (WS-X6324-100FX-MM) provides
24 switched, 100-Mbps, full- or half-duplex ports. (See
has 24 MT-RJ connectors for connection to the MMF cable.
This module is a Class 1 laser product. Refer to the Regulatory Compliance and
Safety Information for the Catalyst 6500 Series Switches for information on
working with lasers.
The QoS port architecture (Rx/Tx) for this module is 1q4t/2q2t.
Chapter 1
Table 1-6 on page 1-47.
Figure
Product Overview
1-13.) The module
78-15725-02