Cisco Catalyst 6500 Series Installation Manual page 34

Supervisor Engines
Table 1-2 Supervisor Engines (continued)
Product Number
Supervisor Engine 720
Supervisor Engine 720
1. Supervisor Engine 1 is not supported in the Catalyst 6513 switch.
2. Specific combinations of supervisor engines and modules may not be supported in your chassis. Refer to
the release notes of the software version running on your system for specific information on modules and
supervisor engine combinations that are not supported.
Catalyst 6500 Series Switch Module Installation Guide
1-10
Description
2
Two Ethernet uplink ports: port 1 supports gigabit
•
Small Form-Factor Pluggable (SFP) module; port 2
configurable with either a gigabit SFP or a
10/100/1000 Mbps RJ-45
• Integrated 720-Gbps Switch Fabric
2 CompactFlash Type II slots (DISK 0 and DISK 1)
•
Must be installed in slots 5 or 6 in a 6-slot and a 9-slot
•
chassis, and slots 7 or 8 in a 13-slot chassis
Requires installation of a high-speed fan tray
•
Policy Feature Card 3A (PFC3A)
•
Multilayer Switch Feature Card 3 (MSFC3) with
•
64-MB bootflash device and 512-MB DRAM
QoS port architecture (Rx/Tx) is 1p1q4t/1p2q2t
•
Figure 1-1 shows the front panel features of Supervisor Engine 1,
shows the front panel features of Supervisor Engine 2, and
front panel features of the Supervisor Engine 720.
Chapter 1 Product Overview
Figure 1-2
Figure 1-3 shows the
78-15725-02