Removing The Supervisor Engine Or A Switching Module - Cisco Catalyst 6500 Series Installation Manual

Removing the Supervisor Engine or a Switching Module

Removing the Supervisor Engine or a Switching
Module
Catalyst 6500 Series Switch Module Installation Guide
3-12
Figure 3-6 Closing the Ejector Levers in a Vertical Slot Chassis
FAN
STATU S
All ejector levers flush
with module faceplate
This section describes how to remove a supervisor engine or a switching module
from the Catalyst 6500 series switch.
Before you remove a supervisor engine, you should first upload the current
configuration to a server using the write {host file | network | terminal}
command. This step saves time when bringing the module back online. You can
recover the configuration by downloading it from the server to the nonvolatile
memory of the supervisor engine.
Chapter 3 Installing the Module
78-15725-02