48-Port 10/100Base-T Ethernet Switching Module (Ws-X6348-Rj-45) - Cisco Catalyst 6500 Series Installation Manual

Chapter 1 Product Overview
48-Port 10/100BASE-T Ethernet Switching Module
(WS-X6348-RJ-45)
Figure 1-16 48-Port 10/100BASE-T Ethernet Switching Module (WS-X6348-RJ-45)
WS-X6348-RJ-45
STATUS
78-15725-02
The 48-port 10/100BASE-T switching module (WS-X6348-RJ-45) provides
48 switched, 10/100-Mbps autosensing, full- or half-duplex ports. (See
Figure 1-16.) The module has 48 RJ-45 connectors for connection to either
Category 3, Category 5, Category 5e, or Category 6 UTP or FTP cable. This
module can be upgraded with an inline-power daughter card to support IP phones.
The QoS port architecture (Rx/Tx) for this module is 1q4t/2q2t.
48 PORT ETHERNET SWITCHING
10/100 BASE-T MODULE
The front panel LEDs are described in
10/100 and 10/100/1000 Ethernet Switching Modules
Table 1-6 on page
Catalyst 6500 Series Switch Module Installation Guide
PHONE
1-47.
1-29