Cisco Catalyst 6500 Series Installation Manual page 77

Chapter 1 Product Overview
Table 1-8 WS-X6182-2PA Supported Cisco 7200 Series and Cisco 7500 Series
WAN Port Adapters
T1/E1 T3/E3 and STM-1
PA-4T+ PA-T3
PA-8T-V35 PA-T3+
PA-8T-232 PA-E3
PA-8T-X21 PA-2T3
PA-MC-4T1 PA-2T3+
PA-MC-8T1 PA-2E3
PA-MC-8E1/120 PA-MC-T3
PA-MC-E3
PA-MC-STM-1
Note
Note
78-15725-02
HSSI
PA-H
PA-2H
For more information about the MSFC and PFC, refer to the Catalyst 6500 Series
Switch Software Configuration Guide.
Throughout this publication, except where noted, the term MSFC refers to both
MSFC and MSFC2, and the term PFC refers to both PFC and PFC2.
To use the FlexWAN module, you must have a supervisor engine with an MSFC
and a PFC. You configure the FlexWAN module through the MSFC.
The STATUS LED on the FlexWAN module front panel (see
indicates the status of the FlexWAN module.
operation.
For information on FlexWAN module hardware and software requirements and
port adapter installation and configuration, refer to the Catalyst 6000 Family
FlexWAN Module Installation and Configuration Note.
ATM
PA-A3-T3
PA-A3-E3
PA-A3-OC3MM
PA-A3-OC3SMI
PA-A3-OC3SML
Table 1-9
Catalyst 6500 Series Switch Module Installation Guide
FlexWAN Module (WS-X6182-2PA)
Packet over SONET
PA-POS-OC3MM
PA-POS-OC3SMI
PA-POS-OC3SML
Figure 1-39)
describes the LED
1-53