Cisco Catalyst 6500 Series Installation Manual page 27

Chapter 1 Product Overview
The uplink ports are fully functional on the redundant supervisor engine in
Note
standby mode.
The Catalyst 6000 series switches support the following hardware:
•
•
•
•
•
78-15725-02
A supervisor engine with two gigabit interface uplinks and an optional
redundant supervisor engine
Supervisor Engine 720 is not supported in the Catalyst 6006 and
Note
Catalyst 6009 switches.
Both supervisor engines in a single chassis must be completely identical. You
can configure the redundant supervisor engines in a Catalyst 6000 series
switch in one of three configurations:
Two supervisor engines, each with no Multilayer Switch Feature Card
–
(MSFC) and no Policy Feature Card (PFC)
Two supervisor engines, each configured with a PFC daughter card
–
Two supervisor engines, each configured with both an MSFC and a PFC
–
daughter card
Additional switching modules (Ethernet, Fast Ethernet, Gigabit Ethernet, and
ATM) in any combination
Five additional switching modules in the Catalyst 6006
–
Eight additional switching modules in the Catalyst 6009
–
The Switch Fabric Modules are not supported in the
Note
Catalyst 6000 series switches.
Hot-swappable fan assembly and modules
Redundant AC-input or DC-input power supplies
Backplane bandwidth of 32 Gbps
Catalyst 6500 Series Switch Module Installation Guide
Catalyst 6000 Series Switches
1-3