Cisco Catalyst 6500 Series Installation Manual page 37

Chapter 1 Product Overview
Table 1-3 Supervisor Engine LEDs (continued)
LED Color/State Description
SWITCH
LOAD
PCMCIA
LINK Green
Orange
Flashing
orange
Off
1. The SYSTEM and PWR MGMT LED indications on a redundant supervisor engine are synchronized to the active supervisor
engine.
2. VTT = voltage termination module. The VTT module terminates signals on the Catalyst switching bus.
3. If no redundant supervisor engine is installed and there is a VTT module minor or major overtemperature condition, the
system shuts down.
RESET Button
Note
CONSOLE Port
78-15725-02
If the switch is operational, the switch load meter indicates (as an
approximate percentage) the current traffic load over the backplane.
The PCMCIA LED is lit when no Flash PC card is in the slot, and it goes
off when you insert a Flash PC card.
The port is operational.
The link has been disabled by software.
The link is bad and has been disabled due to a hardware failure.
No signal is detected.
The RESET button allows you to restart the switch.
Use a ballpoint pen tip or other small, pointed object to access the RESET button.
The CONSOLE port allows you to access the switch either locally (with a console
terminal) or remotely (with a modem). The CONSOLE port is an EIA/TIA-232
asynchronous, serial connection with hardware flow control and an RJ-45
connector.
Catalyst 6500 Series Switch Module Installation Guide
Supervisor Engines
1-13