Catalyst 6000 Series Switches - Cisco Catalyst 6500 Series Installation Manual

Catalyst 6000 Series Switches

Catalyst 6000 Series Switches
Note
Note
Catalyst 6500 Series Switch Module Installation Guide
1-2
IPSec VPN Acceleration Services Module (WS-SVC-IPSEC-1), page 1-66
•
Intrusion Detection System Module (WS-X6381-IDS), page 1-68
•
Content Switching Module (WS-X6066-SLB-APC), page 1-71
•
Switch Fabric Modules, page 1-72
•
Voice-Related Modules, page 1-75
•
Port Addresses, page 1-84
•
Hot Swapping Supervisor Engines and Switching Modules, page 1-87
•
Power Management and Environmental Monitoring, page 1-88
•
The Catalyst 6000 series switches consist of the following two chassis:
Catalyst 6006 (6 slots)
•
Catalyst 6009 (9 slots)
•
These high-performance, modular, frame-based switches support high-density
Fast Ethernet and Gigabit Ethernet in both campus-backbone and
server-aggregation environments. The Catalyst 6006 and the Catalyst 6009
switches have a 32-Gbps switching capacity. Both platforms share the same
supervisor engines, switching modules, and software, and they support redundant
configurations of supervisor engines, power supplies, and port interfaces.
ATM LAN Emulation (LANE) and Multiprotocol over ATM (MPOA) support is
provided by the ATM dual PHY OC-12 LANE/MPOA module.
Specific combinations of supervisor engines and modules may not be supported
in your chassis. Refer to the release notes of the software version running on your
system for specific information on modules and supervisor engine combinations
that are not supported.
Throughout this publication, except where noted, the term supervisor engine is
used to refer to Supervisor Engine 1, Supervisor Engine 2, and Supervisor
Engine 720.
Chapter 1 Product Overview
78-15725-02