48-Port 10/100Base-T Ethernet Switching Module (Ws-X6248-Rj45); 48-Port 10/100Base-T Ethernet Switching Module (Ws-X6248-Tel) - Cisco Catalyst 6500 Series Installation Manual

Chapter 1 Product Overview
48-Port 10/100BASE-T Ethernet Switching Module
(WS-X6248-RJ45)
Figure 1-10 48-Port 10/100BASE-TX Ethernet Switching Module (WS-X6248-RJ45)
WS-X6248-RJ-45
48-Port 10/100BASE-T Ethernet Switching Module
(WS-X6248-TEL)
Figure 1-11 48-Port 10/100BASE-T Ethernet Switching Module (WS-X6248-TEL)
WS-X6248-RJ-TEL
78-15725-02
The 48-port 10/100BASE-T Ethernet switching module (WS-X6248-RJ45)
provides 48 switched 10/100-Mbps autosensing, full or half-duplex ports. (See
Figure 1-10.) The 48 ports have RJ-45 connectors for Category 3, Category 5,
Category 5e, or Category 6 UTP or FTP cable.
The QoS port architecture (Rx/Tx) for this module is 1q4t/2q2t.
48 PORT ETHERNET SWITCHING
10/100 BASE-T MODULE
The front panel LEDs are described in
The 48-port 10/100BASE-T Ethernet switching module (WS-X6248-TEL)
provides 48 switched 10/100-Mbps autosensing, full or half-duplex ports. (See
Figure 1-11.) Four RJ-21 connectors (12 ports per connector) use Category 3,
Category 5, Category 5e, or Category 6 UTP or FTP cable to connect to the
network.
The QoS port architecture (Rx/Tx) for this module is 1q4t/2q2t.
48 PORT ETHERNET SWITCHING
10/100 BASE-T MODULE
The front panel LEDs are described in
10/100 and 10/100/1000 Ethernet Switching Modules
Table 1-6 on page
Table 1-6 on page
Catalyst 6500 Series Switch Module Installation Guide
1-47.
1-47.
1-25