Checking Connectivity; What To Do After Installing Modules And Verifying Connectivity - Cisco Catalyst 6500 Series Installation Manual

What To Do After Installing Modules and Verifying Connectivity

Checking Connectivity

What To Do After Installing Modules and Verifying
Connectivity
Catalyst 6500 Series Switch Module Installation Guide
3-22
To check connectivity on any switching module port, perform these tasks:
Task
Ping a host.
•
If the host is unresponsive, check the
•
IP address of the switch and default IP
route, if appropriate.
For example, to ping a host named server1, enter this command:
Console> ping server1
server1 is alive
Console>
After you verify the supervisor engine or switching module installation and check
connectivity, you must configure the module. For complete information on
configuring the supervisor engine and all modules, refer to the Catalyst 6500
Series Switch Software Configuration Guide or the Catalyst 6500 Series Switch
Cisco IOS Software Configuration Guide. For information on all Catalyst 6500
series switch commands, refer to the Catalyst 6500 Series Switch Command
Reference or the Catalyst 6500 Series Switch Cisco IOS Command Reference
publications.
Chapter 3 Installing the Module
Command
ping host
show interface
show ip route
78-15725-02