Switch Fabric Module 2 (Ws-X6500-Sfm2) - Cisco Catalyst 6500 Series Installation Manual

Chapter 1 Product Overview
Figure 1-47 Switch Fabric Module (WS-C6500-SFM)
STATUS LED
ACTIVE LED
WS-C6500-SFM
SWITCH FABRIC MDL

Switch Fabric Module 2 (WS-X6500-SFM2)

78-15725-02
module, and the module installed in slot 6 functions as the backup. If you reset
the Switch Fabric Module installed in slot 5, the module in slot 6 becomes the
primary.
2 Line X 20 character
LCD display
Two front-panel LEDs provide status information for the module and indicate
whether the module is active. The STATUS LED functions are listed in
on page 1-47. The ACTIVE LED is green when the Switch Fabric Module is
operational and active and is orange when the module is in standby mode.
The front panel on the Switch Fabric Module has a 2-line by 20-character LCD
display. The display allows you to monitor the module's input/outport port traffic
and local bus traffic. The display also shows system information.
Two push button switches control the LCD display:
• SELECT—This switch is used for LCD display menu selection.
NEXT—This switch is used to scroll to the next item on the LCD display
•
menu.
The Switch Fabric Module 2 (WS-X6500-SFM2) can be installed in any
Catalyst 6500 series switch. (See
requires Supervisor Engine 2 and must be installed in slot 5 or slot 6 of the
Catalyst 6506, Catalyst 6509, or Catalyst 6509-NEB switches, or in slot 7 or
slot 8 of the Catalyst 6513 switch.
Figure 1-48.) The Switch Fabric Module 2
Catalyst 6500 Series Switch Module Installation Guide
Switch Fabric Modules
Table 1-6
1-73