Intrusion Detection System Module (Ws-X6381-Ids) - Cisco Catalyst 6500 Series Installation Manual

Intrusion Detection System Module (WS-X6381-IDS)

Intrusion Detection System Module (WS-X6381-IDS)
Note
Catalyst 6500 Series Switch Module Installation Guide
1-68
Table 1-15 IPSec VPN Acceleration Services Module STATUS LED
Color/State Description
Green All diagnostic tests pass. The module is
operational.
Red A diagnostic test other than an individual port test
failed.
Orange Indicates one of three conditions:
Off The module power is off.
For further information on the IPSec VPN Acceleration Services Module, refer to
the IPSec VPN Acceleration Services Module Installation and Configuration
Note.
The Intrusion Detection System Module (IDSM) is part of the Cisco Secure
Intrusion Detection System (Cisco Secure IDS) and is managed by the Cisco
Secure Policy Manager (Cisco Secure PM). (See
provides a graphical interface for the management of security across a distributed
network. The Intrusion Detection System Module performs network sensing,
which involves real-time monitoring of network packets: packet capture and
analysis.
Specific combinations of supervisor engines and modules may not be supported
in your chassis. Refer to the release notes of the software version running on your
system for specific information on modules and supervisor engine combinations
that are not supported.
The module is running through its boot and
•
self-test diagnostic sequence.
The module is disabled.
•
The module is in the shutdown state.
•
Chapter 1 Product Overview
Figure 1-45.) Cisco Secure PM
78-15725-02