SolarEdge StorEdge SE5000-xxS0 series Installation Manual page 63

Creating an Ethernet (LAN) Connection
To connect the Ethernet cable:
1. Remove the inverter cover .
2. Open the communication gland #1.
CAUTION!
The gland includes a rubber waterproof fitting, which should be used to ensure proper sealing.
3. Remove the plastic seal from the large opening that has a cut in the rubber fitting .
4. Remove the rubber fitting from the gland and insert the CAT5/6 cable through the gland and through
the gland opening in the inverter .
5. Push the cable into the cut opening of the rubber fitting.
CAT5/6 standard cables have eight wires (four twisted pairs), as shown in the diagram below. Wire colors
may differ from one cable to another. You can use either wiring standard, as long as both sides of the
cable have the same pin-out and color-coding.
RJ45 Pin #
1
2
3
4
5
6
7
8
1 The inverter connection does not support RX/TX polarity change. Supporting crossover Ethernet cables depends on the
switch capabilities.
62
SolarEdge StorEdge -Single Battery/High Capacity Installation MAN-01-00283-1.1
Figure 31: Rubber fitting
Wire Color
T568B
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
Figure 32: Standard cable wiring
1
T568A
White/Green
Green
White/Orange
Blue
White/Blue
Orange
White/Brown
Brown
10Base-T Signal
100Base-TX Signal
Transmit+
Transmit-
Receive+
Reserved
Reserved
Received-
Reserved
Reserved