SolarEdge StorEdge SE5000-xxS0 series Installation Manual page 39

Step 2: Pairing Power Optimizers to the Inverter
2. Turn the inverter ON/OFF switch to ON within 5 seconds. If you wait longer than 5 seconds the
inverter exits the pairing mode. The following message is displayed indicating that the inverter is
performing the pairing:
P a i r i n g
R e m a i n i n g
3. Wait for the completion of the pairing (remaining seconds is 0). If pairing fails, an error is displayed. In
this case, repeat the pairing steps, and refer to Power Optimizer Troubleshooting on page 85. If the
problem persists, contact SolarEdge Support. When pairing succeeds, the following message is
displayed:
P a i r i n g
P a i r i n g
4.
The system startup process begins:
Since the inverter is ON, the power optimizers start producing power and the inverter starts converting
AC.
WARNING!
When you turn ON the inverter ON/OFF switch, the DC cables carry a high voltage and the power
optimizers no longer output a safe 1V output.
When the inverter starts converting power after the initial connection to the AC, the inverter enters
Standby mode until its working voltage is reached. This mode is indicated by the flickering green inverter
LED.
While the inverter is in Standby mode, it monitors the grid and verifies correct grid voltage and
frequency. The following message is displayed:
W a k i n g
R e m a i n i n g :
The countdown indicates the seconds remaining until entering the Production mode. This time is in
accordance with local regulations and is typically between three to five minutes.
When countdown is complete, the inverter enters Production mode and produces power. The steadily
lit green inverter LED indicates this mode.
38
SolarEdge StorEdge -Single Battery/High Capacity Installation MAN-01-00283-1.1
[ s e c ] : 1 8 0
C o m p l e t e d
U p . . .
0 5 1 S e c