SolarEdge StorEdge SE5000-xxS0 series Installation Manual page 91

General Inverter Error Codes
Error # Single Phase Error # Three Phase
CPU v3.18 CPU v3.19 CPU v3.18
and below and above and below
14 2xE 58/59/60
15 2xF 85, 86, 88,
16, 149, 2x10, 2x95,
153, 181 2x59, 2xB5
90
LCD
Message
CPU v3.19
and above
8x19/ 8x1A/
AC Voltage Too
8x1B High (Line 1/2/3)
8x34, 8x35, DC Voltage Too
High (surge)
8x37
8x3E, 8x49,
Hardware Error
SolarEdge-StorEdge -Single Battery/High Capacity Installation MAN-01-00283-1.1
Cause and Troubleshooting
5. Connect each DC string separately, turn the AC and the inverter ON/OFF switch to
ON, until the error appears for the faulty string.
Do not connect strings with a grounding fault to the inverter. A certified installer must
o
fix the faulty string before connecting it to the inverter
For further documentation, contact SolarEdge Support.
o
If the fault persists:
Check the AC connection to inverter.
o
Verify that the inverter is set to the correct country.
o
Check with the grid operator if a large surge source or irregular load exists near the
o
site.
Verify that the output wire size matches the distance between the inverter and the
o
location of the grid connection.
Use a larger gauge wire for the AC output.
o
Refer to the AC Wiring Application Note
o
http://www.solaredge.com/files/pdfs/application-note-
recommended-wiring.pdf
The SolarEdge system normally eliminates DC overvoltage errors. If the fault persists:
Turn OFF the inverter ON/OFF switch. If after five minutes, the LCD panel does not
o
show a low safety voltage (1V per optimizer), check which string is malfunctioning
and recheck its connections to the inverter.
Proceed according to Power Optimizer Troubleshooting on page 85
o
Re-commission all inverters in the site, as described in Commissioning the
o
Installation on page 34
Contact SolarEdge Support.