Solid State Logic C10 HD Installation Manual page 215

c10 hd SnMp t
RApS
The standard 'trap' objects that are available for the C10 HD system in V1.1/5 software are shown in the following table.
object
sslC10Restarting
sslC10MemLow
sslC10DspReboot
sslC10DspRebootFail
sslC10Psu1Fail
sslC10Psu2Fail
sslC10MainGfx1Fail
sslC10MainGfx2Fail
sslC10LostTileComms
sslC10ResumedTileComms
sslC10Synclost
sslC10SyncReturned
sslC10NowActiveInRedundantPair
sslC10NowDormantInRedundantPair
sslC10DiskStatusNotify
sslC10RaidStatusNotify
C10 HD Installation Manual
From description
System System restarting
System Blackrock DSP card memory low
System A DSP device on the Blackrock DSP card has rebooted
A DSP device on the Blackrock DSP card has failed to
System
reboot
Processor Blackrock processor PSU 1 failure
Processor Blackrock processor PSU 2 failure
Console Primary console TFT meter driver failure
Console Secondary console TFT meter driver failure
System Lost Ethernet communication to the control surface
Recovered Ethernet communication with the control
System
surface
System External (Video/AES) sync lost
System External (Video/AES) sync recovered
Blackrock processor is now the active member of a
System
redundant pair
Blackrock processor is now the dormant member of a
System
redundant pair
SBC system disk SMART status trap. This will be sent upon
SBC
receiving a SMART error from the system hard disks
SBC RAID disk array status trap. This will be sent upon
SBC receiving a change in status from the system RAID disk
array manager
Section 6: Appendices
K: SNMP
| Page 6-29