E: Environmental Specification; E: Environmental Specification - Solid State Logic C10 HD Installation Manual

e: e
nViRonMentAL
Temperature
Relative Humidity
Vibration
Shock
Altitude
(Above sea level)
n R
oteS eLAtinG to
• Any item of electronic equipment can be affected by electrostatic discharge. It is considered good practice to avoid
using fully insulating floor coverings in technical areas.
• Air conditioning will usually be required. Note however, that a cool and dry atmosphere can significantly increase the
likelihood of a build-up of static charge. It is recommended that air conditioning systems are designed such that the
relative humidity does not fall below 30% during periods of operation.
C10 HD Installation Manual
S
peciFicAtion
Operating:
Non-operating:
Max. Gradient:
Operating:
Non-operating:
Max. wet bulb:
Operating:
Non-operating, power off:
Operating:
Non-operating:
Operating:
Non-operating:
S
tAtic And
E: Environmental Specifications
5 to 30 Deg. C
-20 to 50 Deg. C
15 Deg. C/Hour
20 to 80 %
5 to 90 %
29 Deg. C (non-condensing)
< 0.2 G (3 - 100Hz.)
< 0.4 G (3 - 100Hz.)
< 2 G (10mSec. Max.)
< 10 G (10mSec. Max.)
0 to 3000 m
0 to 12000 m
A c
iR onditioninG
Section 6: Appendices | Page 6-17