Solid State Logic C10 HD Installation Manual page 163

iP
The iP Setup display shows the addresses of the console's internal network, and should not be altered unless instructed
to do so by an SSL service engineer. If your C10 is connected to a MORSE system, the iP Setup pop-up must be
configured correctly before you will be able to take full advantage of the IO available via a MORSE router.
Please note that these settings do not refer to the console's connection to an external TCP/IP
network. See Section 3 for information regarding the initial configuration of the console on an external network.
Where there is a redundant core, the two host IP addresses refer to the two cores. If the system has no redundant
core, there will only be one host IP address.
C10 HD Installation Manual Section 5: System Administration
Network Menu
| Page 5-39