Adjusting The Stitch Length; Changing The Sewing Speed - JUKI LZ-2290CS Instruction Manual

4-4. Adjusting the stitch length

1. There may be the cases where the feed amount of the operation panel and the actual sewing
stitch length are different from each other in case of the use in the state other than the standard
delivery or material used. Compensate the stitch length in accordance with the sewing product.
2. Be aware that interference between the throat plate and feed dog can occur depending on
the gauge used. Be sure to check the clearance in the gauge to be used. (The clearance must
be 0.5 mm or more.)
3. When you have changed the stitch length, feed dog height or feed timing, run the sewing
machine at a low speed to make sure that the gauge does not interfere with the changed part.

4-5. Changing the sewing speed

❶ A
❷ ❸
❶ A
❷ ❸
Stitch length is displayed in section A on the
panel. (Example of display : 1.5 mm)
[How to adjust]
1) When
input screen is displayed.
2) Change the stitch length by pressing numeric
keypad ❷ .
(Input unit: 0.1 mm; Input range: -2.5 to 2.5)
3) Confirm your entry by pressing
Then, the sewing screen is displayed.
The sewing speed is displayed in section A on
the panel. (Example of display : 4,000 sti/min)
[How to change]
1) Display the sewing speed entry screen by
pressing
2) Change the sewing speed as desired by
pressing ten keys ❷ .
3) Confirm your entry by pressing
Then, the sewing screen is displayed.
– 26 –
❶ is pressed, the stitch length
❶ .
❸ .
❸ .