JUKI LZ-2290CS Instruction Manual page 54

(2) Adjusting the lower stop position
WARNING :
The needle bar moves during adjustment of this item. Be careful not to place your fingers under the
needle.
<Sewing screen (Maintenance personnel mode)>
<Sewing data edit screen>
❺ ❻
❹
<Needle bar lower stop position setting screen>
❶
❷
❸ ❼
– 49 –
❶ on the sewing screen under
1) Press
the maintenance personnel mode.
The "sewing data edit screen" is displayed.
❷ .
2) Press
The "needle bar lower stop position setting
screen" is displayed.
3) Adjust the lower stop position of the needle
bar following two different adjustment proce-
dures described below.
[Adjustment with the + / - key]
Adjust the needle bar position with
(Value shown in display ❹ will change ac-
cordingly.)
[Adjustment with the main-shaft angle]
Adjust the position of the needle bar by turn-
ing the main shaft. (Value shown in display ❺
will change accordingly.)
❻ to reflect the adjustment value
Press
to ❹ .
4) The operation is confirmed by pressing
❼ . Then, the screen returns to the "sewing
data edit screen".
❸ .