Table of Contents
Advertisement
No.
U182 Sewing counter stopping function
0: The sewing machine does not stop even when the sewing counter completes
counting.
1: When the counter completes counting, the sewing machine start after thread
trimming is prohibited.
* Note that the prohibition function is disabled in the case the initial value of count-
er is 0 (zero).
In addition, the prohibition function is also disabled when the pitch time is selected.
U183 Number of times of thread trimming for sewing counter
U194 Thread tension changeover setting when lifting the presser foot
0: OFF / 1: Normally ON / 2: Only after thread trimming / 3: Only during the imme-
diate stop
* This item is not used for the LZ-2290C-S.
U195 Thread tension when lifting the presser foot (right)
* This item is not used for the LZ-2290C-S.
U199 Pedal giving priority to sewing machine for standing work
The switch which is given priority when the pedal is used for sewing machine for
standing work is set.
0: Start switch is given priority / 1: Start switch is not given priority
U201 Bobbin thread remaining amount to start the tension correction (bobbin
thread remaining amount)
The bobbin thread remaining amount to start the tension correction is set.
* This item is not used for the LZ-2290C-S.
U202 Final tension correction amount (bobbin thread remaining amount)
The tension correction amount for the case the bobbin thread remaining amount is
minimized is set.
* This item is not used for the LZ-2290C-S.
U210 Max. zigzag width limiting method
Method to set the maximum zigzag width limit
1: Center / 2: Right and left
U211
Max. zigzag width limit value (center)
The maximum zigzag width limit value in the case the method to set the maximum
zigzag width limit is set to "Center"
U212 Max. zigzag width limit value (right)
The maximum zigzag width limit value (right side) in the case the method to set the
maximum zigzag width limit is set to "Right and left"
U213 Max. zigzag width limit value (left)
The maximum zigzag width limit value (left side) in the case the method to set the
maximum zigzag width limit is set to "Right and left"
U214 Stitch baseline reference position
The reference position of the stitch baseline is set.
0: Left / 1: Center / 2: Right
U273 Start enable/disable setting when lifting the presser foot
Enable/disable of input for starting the sewing machine after lowering the presser
foot which is placed in its upper position is changed over.
0: Enable / 1: Disable
U318 Correction of position to start the reverse feed lever operation
The position at which the reverse feed lever operation is enabled is set.
Item
– 96 –
Setting range
Unit
ー
0 to 1
ー
1 to 20
ー
0 to 3
ー
0 to 200
ー
0 to 1
0 to 100
%
50 to 200
%
ー
1 to 2
ー
0 to 100
ー
0 to 50
ー
-50 to 0
ー
0 to 2
ー
0 to 1
ー
-40 to 40
Hide quick links:
Advertisement
Table of Contents
