Usb - JUKI LZ-2290CS Instruction Manual

8-10-2. USB

Sewing data, custom pattern data and condensation custom data can be copied on a commercially-available
USB thumb drive.
"8-10-1. Data communication" p. 150
Refer to
drive.
① Position of the USB connector
❶
② Precautions to be taken when handling USB devices
• Do not connect to the USB connection terminal other than the USB memory.
It may cause failure.
• Do not leave the USB device or USB cable connected to the USB port while the sewing machine is in opera-
tion. The machine vibration can damage the port section resulting in loss of data stored on the USB device or
breakage of the USB device or sewing machine.
• Do not insert/remove a USB device during reading a program or sewing data.
It may cause data breakage or malfunction.
• When the storage space of a USB device is partitioned, only one partition is accessible.
• Never forcefully insert a USB thumb drive into the USB connector while carefully checking the orientation of
the USB thumb drive. Forceful insertion of the USB thumb drive can cause failure.
• JUKI does not compensate for loss of data stored on the USB device caused by using it with this sewing ma-
chine.
• In principle, connect only one USB thumb drive to the operation panel. When two or more devices/media are
connected/inserted, the machine will only recognize one of them. Refer to the USB specifications.
• Do not turn the power OFF while the data on the USB flash drive is being accessed.
③ USB specifications
• Conform to USB 1.1 standard
• Applicable devices * 1 ���� USB memory
• Format supported ������ FAT 12, FAT 16, FAT 32
• Applicable medium size �� 4.1MB ~ 2TB
• Consumption current ���� The rated consumption current of the applicable USB devices is 500 mA at the
* 1 : JUKI does not guarantee operation of all applicable devices. Some device may not operate due to a compati-
bility problem.
for details of how to copy the sewing data on a USB thumb
❷
maximum.
– 153 –
[USB thumb drive insertion position]
The USB connector is provided on top ❶ of the op-
eration panel.
To use a USB thumb drive, remove connector cover
❷ and insert the USB thumb drive into the USB con-
nector.
* In the case a USB thumb drive is not used, the
USB connector should be protected with connec-
tor cover ❷ without exceptions.
If dust or the like enters the USB connector, a failure
can be caused.