Door Trims Installation - Fisher & Paykel RS4621F Installation Manual

IMPORTANT!
Miscellaneous
components
The door flow divider is pre-assembled to the door of the product. It blocks the air flow from bypassing in front of the bottom grille.
ReInstall the flow divider
1 Peel the adhesive layer off the flow divider (A).
Flow divider cap
Remove the 8Gx16 countersunk screw from the bottom
(1) 2
of the door and re-install the flow divider using the same
screw. (Do not tighten fully) (B).
3 Press the flow divider firmly against the door panel (C).
Make sure the adhesive layer contacts the door panel.
Re-tighten the screw fully.
4
Door panel side extrusion
(2)
Tools
Hacksaw
5 Attach the flow divider cap to the
flow divider (D).
Note:
When fitting the air flow divider to the door
for a toe kick height greater than 102mm,
the divider requires shortening. Cut along
the outline on both the divider and divider
cover (E) before installation to the door.
Ensure to file the cut portions of the divider
and cover.
@4

DOOR TRIMS INSTALLATION

C
B
Twist to prise open Expose adhesive
Cut airflow divider for 6" toekick
Install the door trims
1 Reinstall the door panel top extrusion to the
top of the door.
– Align the notch (F) of the extrusion with
A
the magnet housing at the top of door (G).
– Clip the trim caps (H) at both ends of
the extrusion to the top of the door.
– Press the top door panel extrusion down
into the top of the door (I) so that the
dual lock strips engage together.
D
Exploded with machine screw
E
Press the door panel side extrusion (J) into the gap between the door
2
and door panel. Align the top of the door panel side extrusion with the
top door panel extrusion. Do on each side.
F
H
H
G
I
I
J
J
J
J
45