Fisher & Paykel RS4621F Installation Manual page 42

IMPORTANT!
Tools
If using Custom door panels, ensure they are prepared as per 'Custom door panel dimensions' section.
●●
Hang the door panel
Remove the gauges and retighten the screws. Open the door and
1
Cross-head screwdriver
loosen the screws at both sides of the door (do not remove) (A).
Hang the door panel with a small angle to the door by locating
2
the holes of the top bracket to the M8 studs (B), and rotate the
door panel down so that the side attachment brackets slide onto
the side screws of the door. (C)
Screw the M8 washer and nut to the stud (D), and re-tighten the side
3
screws (A) to fix the door panel (do not fully tighten). This will allow
Powered driver/drill
opening the door without affecting adjustment of the door panel.
(with 2.5mm bit)
Note: We recommended to load the shelves in the product door
with weights to ensure an accurate door panel gap width.
Weight recommendations:
– 457mm product: 10kg
– 610mm product: 15kg
M4 Hex key
– 762mm product: 20kg
(1)
Adjust the door panel
Note: Check the gaps between door panel/cabinetry using
the gauge (3mm). All door panels have full axis adjustment to
13mm spanner
ensure they are flush with adjacent walls.
(1)
1 To adjust the height of the door panel relative to the door, use
M4 hex key to turn the top M8 screw (E) clockwise to lower or
counter-clockwise to raise the door panel until the gap with the
cabinetry above is 3mm.
2 To adjust the depth of the door panel, loosen the side
screws (F) from each side and slide the panel forward/backward.
Re-tighten once satisfied.
To adjust the door panels further, remove the door panels then
3
loosen the fixing screws for the hanging bracket and move the
bracket sideways to suit. (G)
Once satisfied with the door panel position, fully tighten
4
M8 washer and nut to the stud using a M4 hex key (E).
Fix the locking brackets
Loosen the screw at the bottom of the door, and slide the
1
locking bracket out until it touches the panel (H).
2 Fix the locking bracket to the door panel with 8Gx16
countersunk screw (I).
Re-tighten the screw at the bottom of door (J).
3
40
@1
DOOR PANEL INSTALLATION (CUSTOM)
E
G
F
H
B
D
A
C
J
I