Fisher & Paykel RS4621F Installation Manual page 41

IMPORTANT!
Door handle kit
Ensure the screw pilot holes do not penetrate the full depth of the panel.
●●
Do not place the handle holes in marked areas to avoid clashing with panel attachment brackets.
●●
Minimum panel thickness where screw hole is drilled must be 16mm.
●●
M5x25 Hex screw
(4x)
Remove hanging bracket
Door panel
Remove the M8 washer and M8 nut from the
1
attachment kit
M8 screws at the top the door (A) using the
supplied hex key and spanner.
Side bracket
(6)
Bracket slider
(6)
Bracket spacer
(6)
M5x12 Cross-head screw
(30)
Tools
Remove the M8 washer and M8
2
nut from the M8 screws at the top
the door (B).
Unscrew the adjustment screws
3
by 3mm to move close to the
Powered driver
middle of adjustment range (C).
(with 2.5mm drill bit)
Mark the location of the screw
4
holes and drill pilot holes to the
marked location.
Refer to the custom panel
template in the 'Custom door
M4 hex key
(1) panel dimensions' section.
13mm spanner (1)
@1 DOOR PANEL INSTALLATION (CUSTOM)
C
Attach the door handle
Fix the handle with M5x25 hex screws from the inner
5
edge of the panel (D). Refer to 'Custom door panel
dimensions' section to ensure door handle does not
interfere with side attachment brackets.
Attach the hanging and side brackets
A Mark the centreline from the top of the Custom
6
panel and align with the 'V' notch in the bracket (E).
Align the screw holes of the bracket with the screw
7
holes of the door panel and fix the hanging bracket
to the door panel with M5x12 Cross-head screws (F).
– 6 screws for 457mm
– 10 screws for 610mm and 762mm
Align the side panel bracket assembly (bracket,
8
slider and spacer) to the screw holes on the side
of the door panel and fix with 8Gx16 mush washer
screws (G).
3mm
E
G
B
D
F
G
39