Fisher & Paykel RS4621F Installation Manual page 27

IMPORTANT!
Install fasteners kit
Ensure that the hose is not run over when moving the product/s to prevent damage and possible water leaks.
●●
Use low speed, low torque setting when using a powered driver.
●●
Ensure power cord is not damaged during installation.
●●
Barbed plug
(2)
Positioning the product inside the cabinetry
1 Coil the water hose flat behind the product.
Tools
Before rolling the product into the cabinetry, insert a barbed plug into
2
a large hole on each side of the product to protect the inside of the
cabinetry from being damaged by screws on the sides of the product (A).
Roll the product slowly into the cabinetry. Ensure that the water hose is
3
not run over to prevent damage that can cause a water leak.
Cross-head screwdriver
Continue rolling the product into the cabinetry until the anti-tip bracket
4
overlaps (min 180mm) the back top surface of the product. Refer to
'Cavity Preparation'.
Check the clearance between the floor and the feet. Ensure the rollers
5
of the product can roll freely on the floor.
Powered driver
(optional)
Ruler
!7
SINGLE INSTALLATION
A
Aligning the product inside the cabinetry
Mark the step on each alignment gauge based on the thickness of
6
the door panel to be installed to the door (B).
7 Align the marked steps of the gauges flush with the front surface of
the cabinetry.
– Place a ruler on the steps of the alignment gauges to check if
they are in line (C) relative to the thickness of the door panel.
Check if the gaps between product and cabinetry side walls are
8
even on both sides.
B
C
Mark the step on each alignment gauge
based on the thickness of the door panel
to be installed to the door.
B
C
25