Fisher & Paykel RS4621F Installation Manual page 34

Tools
IMPORTANT!
Ensure the door is in line with the cabinetry front and the product is centred.
●●
All four corners of the product must be supported firmly onto the floor to eliminate any movement.
●●
Installing the product on a soft, uneven, or not level floor may cause twisting and poor door sealing.
●●
Cross-head screwdriver
Adjusting height of the second product inside the cabinetry
Turn the front and rear adjustment screws using a cross-head screwdriver
1
(or powered driver) to extend the feet until it engages the floor.
– One turn of height adjusting nuts is equivalent to 0.5mm of height
Powered driver (optional)
32
adjustment. Clockwise turn raises the height and counter-clockwise
turn lowers height (A).
Front foot
adjustment
!8
DUAL INSTALLATION
A
Rear foot
adjustment
Continue turning the adjusting screws alternately between front and rear
2
feet until you achieve the correct alignment of the second product with the
first product.
3 Once you are satisfied with the alignment, raise the height of the product
by alternately adjusting the front and rear feet until the top surface contacts
the alcove ceiling.
– Check the alignment gauges while adjusting the screws to make sure
you maintain the alignment of both products.
Ensure all feet are positively engaged with the floor.
4
Front foot Rear foot