Fisher & Paykel RS4621F Installation Manual page 49

Tools Removing the top door hinge
Rotate the top hinge (A) outwards and remove
1
the top hinge pocket cover (B) using the flat
head screwdriver in the slot of the cover.
Remove the hinge by unscrewing the M5x12
2
pan head screws (2x) (C), and set aside for
T2 star-head screwdriver
later use.
3 Remove the hinge pocket and top alcove
bracket by unscrewing M5x12 pan head screws
(2x) (D) from the hinge pocket.
Remove the top hinge bracket and spacer (E)
4
by unscrewing the M5x12 countersunk screws
Flat-head screwdriver
(2x) from the top hinge bracket.
For the non-hinge side, remove the top alcove
5
bracket by unscrewing the M5x12 pan head
screws (2x) (F). (Not applicable for RS46).
Removing the bottom door hinge
Rotate the bottom hinge (G) outwards and
6
remove bottom hinge pocket cover (H) using
a flat head screwdriver in the slot.
7 Remove the hinge by unscrewing the M6x16
countersunk screws (2x) (I).
Open the water filter hatch on the bottom
8
(fixed) grille and unscrew the #8x16 screw (J)
while holding the grille in place.
9 Remove the bottom grille by unscrewing the
#8x16 screws (K) from the bottom left and
right of the grille.
Remove bottom hinge bracket by unscrewing
!0
M6x16 countersunk screws (L).
IMPORTANT!
Do not remove plinth-to-cabinet retention brackets!
@5
OPTIONAL — CHANGING OVER DOOR HINGES
F
A
B
C
E
D
Do not remove!
G
H
I
J
K
L
K
Do not
remove!
47