Fisher & Paykel RS4621F Installation Manual page 29

IMPORTANT!
Install fasteners kit
Dual installation applies to two products to be installed side by side.
●●
A joiner kit is required and located in the Freezer model only.
●●
The joiner kit is also available for purchase through an authorised
●●
Fisher & Paykel dealer. Visit fisherpaykel.com for more information.
Refer to 'Cavity dimensions' section for cabinetry overall width for dual
●●
install, and 'Dual installation option' for selecting applicable options.
Cabinet depth alignment
gauge (1)
Top joiner
Attaching the central spacer to cabinetry
bracket kit
Note: The spacer must be attached between
the first and second products. The attachment
location of the spacer to the alcove ceiling
depends on the model of each product.
Central spacer
Measure from the alcove side towards
1
(1)
the centre.
Note: The alcove width for each side depends
on the size of the product to be installed.
8Gx16 Mush washer screw
For example,
(2)
– left side alcove width (A) = 457mm model
– right side alcove width (B) = 762mm model
Tools
Refer to 'Cavity dimensions' section for dual
install options.
Using one depth alignment gauge, mark the
2
location and depth position of the central spacer
Cross-head screwdriver
on the alcove ceiling depending on the door
panel thickness (C).
– Make sure to follow the marked depth of
Fix the central spacer to the alcove ceiling
3
with two 8Gx16 countersunk screws.
Powered driver (optional)
Tighten the screws with a screwdriver or
Powered driver) (E).
the alignment gauge relative to the door
panel (D).
!8
DUAL INSTALLATION
A
C
We recommend to place the product (Freezer) with water connection
●●
first into the cabinetry to allow you to check the connection before
placing the second product.
Follow the steps carefully for the correct installation of first and second
●●
products inside the cabinetry.
B
D
E
27