IMPORTANT!
Door handle kit
Ensure to protect the finish of the Fisher & Paykel Stainless Steel door panels.
●●
Leave the protective film on the panels when hanging and remove the film only when the installation is complete.
●●
M5x25 Hex screw
(4x)
Remove hanging bracket
Door panel
1
Remove the M8 washer and M8 nut from
attachment kit
the M8 screws at the top the door (A)
using the supplied hex key and spanner.
Side bracket
(6)
Bracket slider
(6)
Bracket spacer
(6)
8Gx16 Mush washer screw
(30)
Tools
Remove the hanging bracket
2
from the top of the door
and set aside (B).
3
Unscrew the adjustment
Powered driver
screws by 3mm to move
(with 2.5mm drill bit)
close to the middle of
adjustment range (C).
M4 hex key
(1)
13mm spanner (1)
@0
DOOR PANEL INSTALLATION (STAINLESS STEEL)
B
Attach the door handle
4
Remove the plastic plugs from handle
holes (x4).
5
Align the handle to the holes and secure
with M5x25 hex screws (D).
Attach the hanging and side brackets
6
Align the screw holes of the hanging bracket
A
with the screw holes of the door panel, and
fix with 8Gx16 mush washer screws (E).
– 6x screws for 457mm
– 10x screws for 610mm and 762mm
7
Align the side panel bracket assembly
(bracket, slider and spacer) to the screw
holes on the side of the door panel and fix
with 8Gx16 mush washer screws (F).
C
3mm
D
D
E
F
35