Electrical And Plumbing - Fisher & Paykel RS4621F Installation Manual

IMPORTANT!
Electrical and water connections for these products must be located in an adjacent area
●●
or unit (cabinet or cupboard) that is easily accessible in case of repair or disconnection.
Note: that once installed, the service technician will NOT remove the product from the
●●
cavity to gain access for repair.
1
Cavity size shown for dual columns installation.
!3

ELECTRICAL AND PLUMBING

2
3
1
B
WARNING!
Electric shock hazard! Assume all parts live.
●●
Disconnect supply before servicing and installation.
●●
ELECTRICAL AND PLUMBING CONNECTIONS
Recommended location for connections in adjacent area or unit
1
Alternative location for connections above the cavity
2
Alternative location for connections at rear of cavity
3
Left side of cavity
REAR OF CAVITY
A
Floor
Electrical and water connections must be within this space if located
behind the product and must not protrude from the back wall.
IMPORTANT!
Minimum overall depth of cavity should not be less than 650mm if power plug is located
●●
behind the product.
If connections are located behind the product, ensure that you install an isolating switch
●●
to a location that is easily accessible for repair or disconnection.
ELECTRICAL AND PLUMBING DIMENSIONS
Overall height of supply area
A
Overall depth of supply area
B
Width of notch in supply area
C (both sides)
Height of sides of supply area
D (both sides)
Note: Dimensions are based on minimum depth of cavity.
C
D
mm
229
25
13
127
17