Fisher & Paykel RS4621F Installation Manual page 31

IMPORTANT!
Install fasteners kit
Make sure that all feet engage the floor and evenly support the product.
●●
Tighten the adjustment screw with screwdriver (do not use powered driver).
●●
Barbed plug
(2)
Positioning and aligning the first product inside the cabinetry
1 Coil the water hose flat behind the first product. (Refer to 'Connect to
water and power supply').
Tools
Before rolling the first product, insert a barbed plug into a large hole on
2
the cabinetry side of the product to protect the inside of the cabinetry
from being damaged by screws on the side of the product (A).
3 Roll the first product (preferably, Freezer) inside the cabinetry (B).
– Ensure that the water hose is not run over to prevent damage and
Ruler Continue rolling the product into the cabinetry until the anti-tip bracket
4
overlaps [minimum 180mm the back top surface of the product.
(Refer to ''Cavity Preparation').
Check the clearance between the floor and the feet. Ensure the rollers
5
of the product can roll freely on the floor.
Note: The product can be rolled first into the left side or right side
of the cabinetry depending on your preference.
possible water leak.
A
B
!8
DUAL INSTALLATION
Align the top cap of the first product flush with the front of the spacer (C).
6
Mark the step (D) of each alignment gauge based on the thickness of the
7
door panel to be installed to the door.
Align the marked steps of the gauges flush with the front surface of
8
the cabinetry.
– Place a ruler on the steps of the alignment gauges to check if they
are in line (E) relative to the thickness of the door panel.
Check if the gaps between product and cabinetry side wall are even.
9
D
E
C
29