Before Installation - Fisher & Paykel RS4621F Installation Manual

IMPORTANT!
Ensure your product is not exposed to any heat generating product eg cooktop, oven or dishwasher.
●●
The product has front and rear rollers for moving the product forward and backward. Do not move the product sideways to avoid damaging the rollers or the floor covering/surface.
●●
The product must be installed by a qualified installer, or Fisher & Paykel trained and supported service technician to avoid faulty electrical connection and water leaks.
●●
All connections for water, electrical power and earthing must comply with local codes and ordinances and be made by licensed personnel when required.
●●
Avoid installation of the product/s under a ground fault circuit interrupter (GFCI).
●●
Ensure the product is installed properly. Improper installation that results in product failure is not covered under the product warranty.
●●
Check the installation location
Check the cabinetry
– Check the dimensions of the cabinetry: height (A), width (B), depth (C),
floor level, finished alcove returns.
– Ensure that the ventilation openings in the cabinetry are clear of obstruction.
Check the power supply connection
– Ensure that there is a separate power socket for each product.
– Avoid sharing the power point with other products to prevent accidental
switching off of the product.
– For power requirements, refer to the information on the serial plate.
– Ensure your product is properly grounded (earthed).
– Connect your product to an electrical supply with the fitted plug and lead.
– If power connection is located behind the product, we recommend to install
an isolating switch to a location that is easily accessible to the user for
repair or disconnection.
– Follow local codes and ordinances when installing the product.
Check the water supply connection (for Freezer models only)
– We recommend connecting the hose to exit at an angle if there is not
enough clearance between the cabinet wall and back of product.
– Fisher & Paykel is not liable for damage (including water damage)
caused by faulty installation or plumbing.
Check your product
– Ensure that your product is the correct model as per your order.
– Ensure that the packaging is not damaged upon delivery.
– Check that the components and install kits are complete.
– You have the option to change the door hinge side of your product from
right hand hinge to left hand hinge or vice versa. A hinge change kit is
required for this installation. Refer to 'Optional — Changing over door hinges'
for more information.
!4

BEFORE INSTALLATION

A
C
B
19