Fisher & Paykel RS4621F Installation Manual page 32

IMPORTANT!
Install fasteners kit
Ensure the doors are in line with the cabinetry front and the product is centred.
●●
All four corners of the product must be supported firmly onto the floor to eliminate any movement.
●●
Installing the product on a soft, uneven, or not level floor may cause twisting and poor door sealing.
●●
Adjusting height of the product inside the cabinetry
8Gx16 Countersunk screw
(5)
Turn the front and rear adjustment
1
screws using a cross-head
screwdriver (or powered driver)
Tools
to extend the feet until it engages
the floor.
– One turn of height adjusting
Cross-head screwdriver
Powered driver (optional)
Front foot
Continue turning the adjusting screws alternately between front
2
and rear feet until you achieve the correct alignment.
Once you are satisfied with the alignment, raise the height of the
3
product by alternately adjusting the front and rear feet until the
top surface contacts the alcove ceiling.
– Check the alignment gauges while adjusting the screws to
Ensure all feet are positively engaged with the floor.
4
30
nuts is equivalent to 0.5mm
of height adjustment.
Front foot
Turn clockwise to raise the
adjustment
height and counter-clockwise
to lower height (A).
make sure you maintain the alignment of the product.
!8 DUAL INSTALLATION
A
Rear foot
adjustment
Rear foot
Fixing the first product inside the cabinetry
Fix each top bracket of first product to ceiling surface with two (2x) 8Gx16
5
countersunk screws (B).
– 457mm column = 1 bracket
– 610mm column = 2 brackets
– 762mm column = 2 brackets
Note: Ensure the product does not move as you open the door when you
install the screws.
Fix the alcove side bracket to alcove side surface with one 8Gx16
6
countersunk screw (C).
B
C
C
Alcove side bracket
Note: Image shows 457mm (first product) with 1 top bracket.
B