Fisher & Paykel RS4621F Installation Manual page 33

Install fasteners kit Positioning and aligning the second product inside the cabinetry
Barbed plug
(2)
Tools
Ruler
A
Before rolling the second product, insert a barbed plug into a large
1
hole on the cabinetry side of the product to protect the inside of the
cabinetry from being damaged by screws on the side of the product (B).
Roll the second product into the cabinetry side by side with the first
2
product. (A)
Continue rolling the product into the cabinetry until the anti-tip bracket
3
overlaps (min 180mm) the back top surface of the product. Refer to
'Cavity Preparation'.
Check the clearance between the floor and the feet. Ensure the rollers of
4
the product can roll freely on the floor.
!8
DUAL INSTALLATION
B
5 Align the top cap of the second product flush with the central spacer
and top cap of first product (C).
D
E
Mark the step (D) of each alignment gauge based on the thickness of
6
the door panel to be installed to the door.
Align the marked steps of the gauges flush with the edges of the
7
cabinetry side walls.
– Place a ruler on the steps of the alignment gauges to check if they
are in line (E) relative to the thickness of the door panel.
Check if the gaps between product and cabinetry side wall are even.
8
C
31