Fisher & Paykel RS4621F Installation Manual page 50

Tools Moving the sensor housing
(RS46 & RS61 only)
T2 star-head screwdriver
Flat-head screwdriver
1 Unclip the reed switch from the housing (A).
Unhook the interceptor board harness from
2
sensor housing so harness is loose (B).
3 Remove the #8x16 screws (2x) from the sensor
housing (C).
48
@5
OPTIONAL — CHANGING OVER DOOR HINGES
A
B
C
4 Move the sensor housing so that the
opposite reed switch clip is aligned with
the centre of the cabinet (D).
D
5 Reinstall the sensor housing using #8x16 screws
(2x) into the pre-drilled holes in the cabinet top
panel (E).
Clip the reed switch into the sensor housing in the
6
pocket closest to the centreline of the cabinet (F).
Press the harness from the interceptor board into
7
the forks on the sensor housing (G).
E
F
G