Custom Door Panel Installation Dimensions - Fisher & Paykel ACTIVESMART RS9120W Installation Manual

The drawings below apply to Automatic ice models, (RS9120W(R/L)J). Dimensions apply for the preparation and installation of custom door panels.
For Dwg and Dxf files of the below panel preparation download the folder on thekitchentools.fisherpaykel.com
764mm
558mm
347mm
141mm
Ensure handle is mounted
65mm from edge of panel
to the centre – this will avoid
interference with brackets.
All measurements
to be made from
37mm
bottom left corner.
TOP PANEL – REAR VIEW
10
7

CUSTOM DOOR PANEL INSTALLATION DIMENSIONS

Ø 2.5mm REF
12x Pilot holes recommended for bracket attachment.
(Do not penetrate front surface.)
869mm
385mm
128mm
87mm 29mm
All measurements to be made
from top and centreline.
416mm
Cutouts are located in attachment bracket for Fisher & Paykel handles only.
If locating custom handle in the shaded area shown above, ensure handle screw
heads are countersunk into back of panel to avoid interference with hanging bracket.
BOTTOM PANEL – REAR VIEW
Ø 2.5mm REF
10x Pilot holes recommended
for bracket attachment.
(Do not penetrate front surface.)