Fisher & Paykel RS4621F Installation Manual page 28

IMPORTANT!
Tools
Ensure the doors are in line with the cabinetry front and the product is centred.
●●
All four corners of the product must be supported firmly onto the floor to
●●
eliminate any movement. Installing the product on a soft, uneven, or not level
floor may cause twisting and poor door sealing.
Cross-head screwdriver
Adjusting height of the product inside the cabinetry
Turn the front and rear adjustment
1
screws using a cross-head
screwdriver (or powered driver)
to extend the feet until it engages
Powered driver (optional)
the floor.
– One turn of height adjusting
– Align bottom gauge.
– Adjust height.
– Align top gauge.
Front foot
2 Continue turning the adjusting screws alternately between front and rear
feet until you achieve the correct alignment.
Once you are satisfied with the alignment, raise the height of the product
3
by alternately adjusting the front and rear feet until the top surface contacts
the alcove ceiling.
– Check the alignment gauges while adjusting the screws to make sure
Ensure all feet are positively engaged with the floor.
4
26
nuts is equivalent to 0.5mm
of height adjustment.
Clockwise turn raises the
height and counter-clockwise
turn lowers height (A).
you maintain the alignment of the product.
!7
SINGLE INSTALLATION
A
Front foot Rear foot
adjustment adjustment
Rear foot
IMPORTANT!
Make sure to remove the depth alignment brackets before fixing
●●
the product inside the cabinetry.
Open the product door to remove the alignment brackets from
●●
both sides of the product, and then re-tighten the screws.
Fixing the product inside the cabinetry
B
C
5 Fix each top bracket to the ceiling surface with two 8Gx16 countersunk
screws (B).
– 457mm column = 1 bracket
– 610mm column = 2 brackets
– 762mm column = 2 brackets
Note: Make sure the product does not move as you open the door
when you install the screws.
Fix the alcove side brackets (1x per each side) to the alcove side
6
surface with 8Gx16 countersunk screws (C).
B B
C C