Fisher & Paykel RS4621F Installation Manual page 38

Tools
Hang the door panel
Remove the gauges and retighten the screws. Open the
1
door and loosen the screws at both sides of the door
(do not remove) (A).
Hang the door panel with a small angle to the door by
2
locating the holes of the top bracket to the M8 studs (B),
Cross-head screwdriver
and rotate the door panel down so that the side attachment
brackets slide onto the side screws of the door. (C)
Screw the M8 washer and nut to the stud (D), and
3
re-tighten the side screws (A) to fix the door panel (do not
fully tighten). This will allow opening the door without
affecting adjustment of the door panel.
Powered driver
Note:
(with 2.5mm drill bit)
We recommended to load the shelves in the product door
with weights to ensure an accurate door panel gap width.
Weight recommendations:
– 457mm product: 10kg
– 610mm product: 15kg
– 762mm product: 20kg
M4 hex key
(1)
Adjust the door panel
Note: Check the gaps between door panel/cabinetry using
the gauge (3mm). All door panels have full axis adjustment
13mm spanner
to ensure they are flush with adjacent walls.
(1)
1 To adjust the height of the door panel relative to the door,
use M4 hex key to turn the top M8 screw (E) clockwise to
lower or counter-clockwise to raise the door panel until the
gap with the cabinetry above is 3mm.
2 To adjust the depth of the door panel, loosen the side
screws (F) from each side and slide the panel forward/
backward. Re-tighten once satisfied.
To adjust the door panels further, remove the door panels
3
then loosen the fixing screws for the hanging bracket and
move the bracket sideways to suit. (G)
Once satisfied with the door panel position, fully tighten M8
4
washer and nut to the stud using the supplied hex key and
spanner (E).
Fix the locking brackets
Loosen the screw at the bottom of the door, and slide the
1
locking bracket out until it touches the panel (H).
Fix the locking bracket to the door panel with 8Gx16
2
countersunk screw (I).
Re-tighten the screw at the bottom of door (J).
3
36
@0
DOOR PANEL INSTALLATION (STAINLESS STEEL)
E
G
F
H
B
D
A
C
J
I